Allied Telesis AT-S63 - Manual (Page 316)

Chapter 19: Spanning Tree and Rapid Spanning Tree Protocols
316 Section IV: Spanning Tree Protocols
10. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Note
All changes to a port’s RSTP settings, with the exception of port
cost, are activated immediately. A change to the port cost value
requires you to reset the switch. A new port cost value is not
implemented until the unit is reset.
Resetting RSTP
to the Default
Settings
To reset RSTP to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select Layer 2.
The Layer 2 page is displayed with the MAC Address tab shown by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 124 on page 303.
4. Click Configure.
The Configure RSTP Bridge Parameters tab is shown in Figure 131 on
page 313.
5. Click Defaults.
The RSTP settings are returned to their default values.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Displaying RSTP
Settings
To display RSTP parameter settings, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Layer 2 option.
3. The Layer 2 page is displayed with the MAC Address tab displayed by
default, as shown in Figure 127 on page 309.