Allied Telesis AT-S63 - Manual (Page 70)

Chapter 4: SNMPv1 and SNMPv2c
70 Section I: Basic Operations
Figure 17. Modify SNMPv1 & SNMPv2c Community Page
6. Modify the following parameters:
Community Name
This field is not configurable from this page. It is the name of the
SNMP community.
Status
Click Enable to enable the SNMP community. Click Disable to disable
the SNMP community.
Access Mode
Click Read Only to allow read access to the SNMP community. Click
Read-Write to allow read-write access to the SNMP community.
Allow Any Station
Click this option to allow any SNMP manager to access the switch.
When you click this option, a warning message appears on the screen.
Click OK to continue.
Manager IP Address1 through Manager IP Address 8
Enter an IP Address of a switch that is permitted SNMP manager