Allied Telesis AT-S63 - Manual (Page 236)

Chapter 18: SNMPv3
236 Section III: SNMPv3
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
ˆ “Creating a User Table Entry” on page 236
ˆ “Deleting a User Table Entry” on page 239
ˆ “Modifying a User Table Entry” on page 240
For reference information about the SNMPv3 User Table, see Chapter 22,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 89 on page 234.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure at the bottom of the tab.