Allied Telesis AT-S63 - Manual (Page 412)

Chapter 25: 802.1x Port-based Network Access Control
412 Section VI: Port Security
Type
This parameter specifies the type of RADIUS accounting. The default
is Network. You cannot change this value.
Enable Update
This parameter controls whether the switch is to send interim
accounting updates to the RADIUS server. A check in the box
indicates that updating is enabled. No check in the box means that
updating is disabled.
Update Interval
Specifies the intervals at which the switch sends interim accounting
updates to the RADIUS server. The range is 30 to 300 seconds. The
default is 60 seconds.
5. Click Apply.
Changes to the accounting settings are immediately implemented on
the switch.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Displaying the
RADIUS
Accounting
Settings
To display the RADIUS accounting settings, perform the following
procedure:
1. From the home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Network Security option.
The Network Security page is displayed with the Port Security tab
selected by default, as shown in Figure 160 on page 395.
3. Select the 802.1x Port Access tab.