Allied Telesis AT-S63 - Manual (Page 322)

Chapter 20: Multiple Spanning Tree Protocol
322 Section IV: Spanning Tree Protocols
Configuring MSTP
This section contains the following procedures:
ˆ “Configuring MSTP Parameters,” next
ˆ “Configuring the CIST Priority” on page 325
ˆ “Creating, Deleting, or Modifying MSTI IDs” on page 326
ˆ “Adding, Removing, or Modifying VLAN Associations to MSTIs” on
page 330
ˆ “Configuring MSTP Port Parameters” on page 333
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to “Enabling MSTP” on page 320.
Note
When MSTP is enabled, the GVRP tab is not shown on the
Configuration or Monitoring Layer 2 page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 124 on page 303.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 136.