Allied Telesis AT-S63 - Manual (Page 193)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 193
4. Click Create.
The Create Flow Group page opens, as shown in Figure 66.
Figure 66. Create Flow Group Page
5. Configure the following parameters as necessary:
ID
Specifies the ID number for this flow group. The range is 0 to 1023.
DSCP
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
Remark Priority
Replaces the user priority value in the packets with the new value
specified in the Priority parameter.
Description
Specifies the flow group description. A description can be up to 15
alphanumeric characters, including spaces.
Priority (802.1p)
Specifies a new user priority value for the packets. The range is 0 to 7.
Classifier List
The classifiers to be assigned to the policy. The specified classifiers
must already exist. To select more than one classifier, use <Ctrl> click.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)