Displaying the port trunks, Figure 32: port trunking tab (monitoring) – Allied Telesis AT-S63 User Manual
Page 110
Chapter 7: Static Port Trunks
110
Section I: Basic Operations
Displaying the Port Trunks
To display the port trunks, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected by
default, as shown in Figure 22 on page 85.
3. Select the Port Trunking tab.
The Port Trunking tab is shown in Figure 32.
Figure 32. Port Trunking Tab (Monitoring)
The Port Trunking tab displays a table that contains the following
columns of information:
ID
The ID number of the trunk.
Name
The name of the trunk.
Type
The load distribution method. The possible settings are:
SA - Source MAC address (Layer 2)