Allied Telesis AT-S63 - Manual (Page 103)

Chapter 7
Port Parameter Commands
This chapter contains the following commands:
❑ “ACTIVATE SWITCH PORT” on page 104
❑ “DISABLE INTERFACE LINKTRAP” on page 105
❑ “DISABLE SWITCH PORT” on page 106
❑ “DISABLE SWITCH PORT FLOW” on page 107
❑ “ENABLE INTERFACE LINKTRAP” on page 108
❑ “ENABLE SWITCH PORT” on page 109
❑ “ENABLE SWITCH PORT FLOW” on page 110
❑ “RESET SWITCH PORT” on page 111
❑ “SET SWITCH PORT” on page 112
❑ “SET SWITCH PORT RATELIMITING” on page 117
❑ “SHOW INTERFACE” on page 120
❑ “SHOW SWITCH PORT” on page 122
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on port parameters, refer to Chapter 6,
“Port Parameters” in the AT-S63 Management Software Menus
Interface User’s Guide.