Enable portaccess|portauth – Allied Telesis AT-S63 User Manual
Page 428
Advertising
Chapter 33: 802.1x Port-based Network Access Control Commands
428
ENABLE PORTACCESS|PORTAUTH
Syntax
enable portaccess|portauth
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
None.
Description
This command activates 802.1x Port-based Network Access Control on
the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on the
switch before you activate port-based access control. Refer to “SET
AUTHENTICATION” on page 422.
Example
The following command enables 802.1x Port-based Network Access
Control on the switch:
enable portaccess
Advertising