Reset switch port – Allied Telesis AT-S63 User Manual
Page 111
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
111
RESET SWITCH PORT
Syntax
reset switch port=
port
Parameter
port
Specifies the port to reset. You can specify the ports
individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current
operating parameter settings. This command performs the same
function as the SOFTRESET parameter in the SET SWITCH PORT
command.
Example
The following command resets ports 5 to 8:
reset switch port=5-8
Advertising