Allied Telesis AT-S63 - Manual (Page 59)

AT-S63 Management Software Command Line Interface User’s Guide
59
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. The status will be either “enabled” or “disabled.”
The default setting for DHCP and BOOTP is disabled.
To enable the DHCP and BOOTP client software, refer to “ENABLE
DHCPBOOTP” on page 38 or “ENABLE IP REMOTEASSIGN” on page 39. To
disable the client software, refer to “DISABLE DHCPBOOTP” on page 35
or “DISABLE IP REMOTEASSIGN” on page 36.
Example
The following command displays the status of the DHCP and BOOTP
client software:
show dhcpbootp