Allied Telesis AT-S63 User Manual

Page 173

Advertising

AT-S63 Management Software Command Line Interface User’s Guide

173

An example of the event log is shown in Figure 1. The example
uses the full display mode.

Figure 1. Event Log Example

The columns in the log are described below:

❑ S (Severity) - The event’s severity. Refer to Table 4 on page 172.

❑ Date/Time - The date and time the event occurred.

❑ Event - The module within the AT-S63 software that generated

the event followed by a brief description of the event. For a list of
the AT-S63 modules, see Table 3 on page 171.

❑ Event ID - A unique number that identifies the event. (Displayed

only in the full display mode.)

❑ Filename and Line Number - The subpart of the AT-S63 module

and the line number that generated the event. (Displayed only in
the full display mode.)

Examples

The following command displays all the entries in the event log stored in
permanent memory:

show log=permanent

The following command displays the events stored in temporary
memory in the full display mode, which adds more information:

show log=temporary full

The following command displays only those entries stored in temporary
memory and associated with the AT-S63 modules FILE and QOS:

show log=permanent module=file,qos

S Date

Time

EventID

Source File:Line Number

Event

------------------------------------------------------------------
I 2/01/04