Set snmpv3 targetparams – Allied Telesis AT-S63 User Manual
Page 289
AT-S63 Management Software Command Line Interface User’s Guide
289
SET SNMPV3 TARGETPARAMS
Syntax
set snmpv3 targetparams=
targetparams
username=
username
[securitymodel=v1|v2c|v3] [messageprocessing=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] [storagetype=volatile|nonvolatile]
Parameters
targetparams
Specifies the target parameters name, up to 32
alphanumeric characters.
username
Specifies the user name.
securitymodel
Specifies the security model of the above user
name. The options are:
v1
Associates the Security Name, or User
Name, with the SNMPv1 protocol.
v2c
Associates the Security Name, or User
Name, with the SNMPv2c protocol.
v3
Associates the Security Name, or User
Name, with the SNMPv3 protocol.
messageprocessing Specifies the SNMP protocol that is used to
process, or send messages. Configure this
parameter only if you have selected the
SNMPv1 or SNMPv2c protocols as the security
model. If you have selected the SNMPv3
protocol as the security model, message
processing is automatically set to the SNMPv3
protocol. The options are:
v1
Messages are processed with the
SNMPv1 protocol.
v2c
Messages are processed with the
SNMPv2c protocol.
v3
Messages are processed with the
SNMPv3 protocol.
securitylevel
Specifies the security level. The options are: