Set switch mirror – Allied Telesis AT-S63 User Manual
Page 140
Chapter 10: Port Mirroring Commands
140
SET SWITCH MIRROR
Syntax
set switch mirror=
port
Parameter
mirror
Specifies the destination port for the port mirror. This is the
port to where the traffic from the source ports will be copied.
You can specify only one port as the destination port.
Specifying “0” (zero) disables port mirroring.
Description
This command enables mirroring and specifies the destination port, or
disables mirroring. To select the source ports, refer to “SET SWITCH PORT
MIRROR” on page 141.
Note
When a transceiver is inserted into an uplink slot and a link is
established, that slot becomes a primary uplink port and the
corresponding backup port, 23R or 24R, automatically transitions to
redundant uplink status. Any settings for port mirroring remain
intact when the backup port makes the transition to a redundant
uplink state.
Examples
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command disables port mirroring:
set switch mirror=0