Allied Telesis AT-S63 User Manual
Page 47
AT-S63 Management Software Command Line Interface User’s Guide
47
This command does not change the assignment of the active boot
configuration file, the configuration file the switch uses the next time it is
reset. If you reset or power cycle the switch, the switch uses the previous
configuration. To change the active boot configuration file, refer to “SET
CONFIG” on page 150.
Your local or remote management session with the switch ends when
you reset the switch. You must reestablish the session to continue
managing the switch.
Example
The following command configures the switch using the configuration
file named
switch12.cfg
:
restart switch config=switch12.cfg
The following command resets the switch to its default values:
restart switch config=none