Set dos – Allied Telesis AT-S63 User Manual
Page 442
Chapter 34: Denial of Service (DoS) Defense Commands
442
SET DOS
Syntax
set dos ipaddress=
ipaddress
subnet=
mask
uplinkport=
port
Parameters
ipaddress
Specifies the IP address of one of the devices
connected to the switch, preferably the lowest IP
address.
subnet
Specifies the subnet mask of the LAN. A binary “1”
indicates the switch should filter on the
corresponding bit of the address, while a “0”
indicates that it should not.
uplinkport
Specifies the port on the switch that is connected to
a device (for example, a DSL router) that leads
outside the network. You can specify only one port.
This parameter is required only for the Land defense.
Description
This command is required for the SMURF and Land defenses. The SMURF
defense uses the LAN address and mask to determine the broadcast
address of your network. The Land defense uses this information to
determine which traffic is local and which is remote to your network.
As an example, assume that the devices connected to a switch are using
the IP address range 149.11.11.1 to 149.11.11.50. The IP address would
be 149.11.11.1 and the mask would be 0.0.0.63.
Examples
The following command sets the IP address to 149.11.11.1 and the mask
to 0.0.0.63:
set dos ipaddress=149.11.11.1 subnet=0.0.0.63
The following command sets the IP address to 149.22.22.1, the mask to
0.0.0.255, and the uplink port for the Land defense to port 24:
set dos ipaddress=149.22.22.1 subnet=0.0.0.255 uplinkport=24