Allied Telesis AT-S63 - Manual (Page 279)

AT-S63 Management Software Command Line Interface User’s Guide
279
SET SNMPV3 ACCESS
Syntax
set snmpv3 access= access [securitymodel=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] readview=
readview writeview= writeview
notifyview= notifyview [storagetype=volatile|nonvolatile]
Parameters
access Specifies the name of the group, up to 32
alphanumeric characters.
securitymodel Specifies the security model. Options are:
v1 Associates the Security Name, or User
Name, with the SNMPv1 protocol.
v2c Associates the Security Name, or User
Name, with the SNMPv2c protocol.
v3 Associates the Security Name, or User
Name, with the SNMPv3 protocol.
securitylevel Specifies the security level. The options are:
noauthentication This option provides no authentication protocol and
no privacy protocol.
authentication This option provides an authentication protocol, but
no privacy protocol.
privacy This option provides an authentication protocol and
the privacy protocol.
readview Specifies a Read View Name that allows the users
assigned to this Group Name to view the
information specified by the View Table entry.
writeview Specifies a Write View Name that allows the users
assigned to this Security Group to write, or modify,
the information in the specified View Table.
notifyview Specifies a Notify View Name that allows the users
assigned to this Group Name to send traps
permitted in the specified View.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are: