Allied Telesis AT-S63 - Manual (Page 364)

Chapter 26: Management ACL Commands
364
SET MGMTACL STATE
Syntax
set mgmtacl state=disable|enable
Parameters
state Sets the state of the Management ACL. The options are:
enable Enables the Management ACL.
disable Disables the Management ACL. This is the
default setting.
Description
This command enables or disables the Management ACL.
Note
Activating the Management ACL without entering any access
control entries (ACEs) prohibits you from remotely managing the
switch from a Telnet or web browser management session.
Example
The following command enables the Management ACL:
set mgmtacl state=enable