Allied Telesis AT-S63 - Manual (Page 147)

AT-S63 Management Software Command Line Interface User’s Guide
147
CREATE CONFIG
Syntax
create config=" filename .cfg"
Parameter
config Specifies the name of a new configuration file. If the
filename contains spaces, it must be enclosed in
double quotes. Otherwise, the quotes are optional.
Description
This command creates a new configuration file containing the
commands required to recreate the current configuration of the switch.
The CONFIG parameter specifies the name of the configuration file to
create. The file extension must be “.cfg”. If the file already exists, it is
replaced. If the file does not exist it is created.
The filename can be from 1 and 15 alphanumeric characters, not
including the “.cfg” extension. Spaces are allowed. Be sure to enclose the
name in double quotes if you include a space in the name. Wildcards are
not allowed.
This command does not change the assignment of the active boot
configuration file, which is the file the switch uses to configure itself the
next time it is reset or power cycled. To assign the new configuration file
as the active boot configuration file, refer to “SET CONFIG” on page 150.
Example
The following command creates the new configuration file Switch12.cfg.
The file will contain all of the commands necessary to recreate the
switch’s current configuration:
create config=Switch12.cfg