Show switch port – Allied Telesis AT-S63 User Manual
Page 122
Chapter 7: Port Parameter Commands
122
SHOW SWITCH PORT
Syntax
show switch port[=
port
]
Parameter
port Specifies
the
port
whose parameter settings you
want to view. You can specify more than one port at
a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22). All ports are displayed
if you omit the port number.
Description
This command displays a port’s operating parameters, such as speed
and duplex mode. For details on port parameters, refer to Chapter 6,
“Port Parameters” in the AT-S63 Management Software Menus Interface
User’s Guide.
Examples
The following command displays the operating settings for all ports:
show switch port
The following command displays the operating settings for port 14:
show switch port=14