Allied Telesis AT-S63 - Manual (Page 170)

Chapter 13: Event Log Commands
170
SHOW LOG
Syntax
show log=permanent|temporary [full] [module= module ]
[reverse] [severity= severity ]
Parameters
log Specifies which of the two event logs you want to
view. The options are:
permanent Displays the events stored in
permanent memory.
temporary Displays the events stored in
temporary memory.
full Specifies the amount of information displayed by
the log. Without this option, the log displays the
time, module, severity, and description for each
entry. With it, the log also displays the filename, line
number, and event ID.
module Displays events associated with a particular AT-S63
module. For a list of modules, refer to Table 3 on
page 171.
reverse Controls the order of the events in the log. Without
this option, the events are displayed oldest to
newest. With this option, the events are displayed
newest to oldest.
severity Displays events of a selected severity. Choices are I
for Informational, E for Error, W for Warning, D for
Debug, and ALL for All. The default is informational,
error, and warning. You can select more than one
severity at a time, for example, E,W.
Description
This command displays the entries stored in an event log.
An event log can display entries in two modes: normal and full. In the
normal mode, a log displays the time, module, severity, and description
for each entry. In the full mode, a log also displays the filename, line
number, and event ID. If you want to view the entries in the full mode,
use the FULL parameter. To view entries in the normal mode, omit the
parameter.