Set switch port intrusion – Allied Telesis AT-S63 User Manual
Page 350
Advertising
Chapter 25: Port Security Commands
350
SET SWITCH PORT INTRUSION
Syntax
set switch port=
port
intrusion=discard|trap|disable
Parameters
port
Specifies the port where you want to change the
intrusion action. You can specify more than one port
at a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22).
Description
This command changes the security intrusion action on a port. This
command applies only to ports operating in the Limited security mode.
Example
The following command changes the intrusion action to trap on ports 12
and 21:
set switch port=12,21 intrusion=trap
Advertising