Set dos land – Allied Telesis AT-S63 User Manual
Page 445
AT-S63 Management Software Command Line Interface User’s Guide
445
SET DOS LAND
Syntax
set dos land port=
port
state=enable|disable
[mirrorport=
port
]
Parameters
port
Specifies the switch port on which you want to enable
or disable the Land defense. You can specify more
than one port at a time.
state
Specifies the state of the Land defense. The options
are:
enable
Activates the defense.
disable
Deactivates the defense. This is the default.
mirrorport
Specifies a port where invalid traffic is copied. You can
specify only one port.
Description
This command enables and disables the Land DoS defense. For an
explanation of this attack and the AT-S63 defense mechanism, refer to
Chapter 31, “Denial of Service Defense” in the AT-S63 Management
Software Menus Interface User’s Guide.
Example
The following command activates the Land defense on ports 5 and 7:
set dos land port=5,7 state=enable