Allied Telesis AT-S63 - Manual (Page 133)

AT-S63 Management Software Command Line Interface User’s Guide
133
CREATE SWITCH TRUNK
Syntax
create switch trunk= name port= ports
[select=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
Parameters
trunk Specifies the name of the trunk. The name can be up
to 16 alphanumeric characters. No spaces or special
characters are allowed.
port Specifies the ports to be added to the port trunk. You
can specify the ports individually (for example, 5, 7,
22), as a range (for example, 18-23), or both (for
example, 1, 5, 14-22).
select Specifies the load distribution method. Options are:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source address/destination MAC
address.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source address/destination IP
address.
Description
This command creates a port trunk. To create the trunk, you specify the
ports on the switch that will constitute the trunk.
Note
All ports in a trunk must operate at the same speed. When you
include port 23R or 24R in a trunk and the port transitions to
redundant uplink status, the port speed is automatically adjusted to
1000 Mbps. If the other ports in the trunk are operating at a different
speed, port trunking may be unpredictable. Because of these port
speed variables, Allied Telesyn suggests that you not include port
23R or 24R in a port trunk.