Set qos cosp – Allied Telesis AT-S63 User Manual
Page 180
Chapter 14: Quality of Service (QoS) Commands
180
SET QOS COSP
Syntax
set qos cosp=
priority-number
qid=
queue-number
Parameters
cosp
Specifies the Class of Service (CoS) priority level. The
CoS priority levels are 0 through 7, with 0 as the
lowest priority and 7 as the highest. You can specify
more than one priority to assign to the same egress
queue.
qid
Specifies the egress queue number. The egress
queues are numbered 0 through 7, with queue 0 as
the lowest priority and 7 as the highest.
Description
This command maps CoS priorities to port egress queues. You must
specify both the priority and the queue ID. You can assign more than one
priority to an egress queue. Table 5 on page 178 lists the default
mappings between the eight CoS priority levels and the eight egress
queues of a switch port.
Note
This command is equivalent to “MAP QOS COSP” on page 178.
Example
The following command maps priorities 5 and 6 to egress queue 1:
set qos cosp=5,6 qid=1