Allied Telesis AT-S63 - Manual (Page 41)

AT-S63 Management Software Command Line Interface User’s Guide
41
PING
Syntax
ping ipaddress
Parameter
ipaddress Specifies the IP address of an end node you want the
switch to ping.
Description
This command instructs the switch to ping an end node. You can use this
command to determine whether a valid link exists between the switch
and another device.
Note
The switch must have an IP address and subnet mask in order for
you to use this command.
Example
The following command pings an end node with the IP address of
149.245.22.22
ping 149.245.22.22
The results of the ping are displayed on the screen.