Allied Telesis AT-S63 - Manual (Page 424)

Chapter 32: TACACS+ and RADIUS Commands
424
SHOW AUTHENTICATION
Syntax
show authentication [=tacacs|radius]
Parameters
None.
Description
This command displays the following information about the
authenticated protocols on the switch:
❑ Status - The status of your authenticated protocol: enabled or
disabled.
❑ Authentication Method - The authentication protocol activated
on your switch. Either TACACS+ or RADIUS protocol may be active.
The TACACS+ protocol is the default.
❑ The IP addresses of up to three authentication servers.
❑ The server encryption keys, if defined.
❑ TAC global secret - The global encryption code that applies to all
authentication servers.
❑ Timeout - The length of the time, in seconds, before the switch
assumes the server will not respond.
Entering the command without specifying either TACACS or RADIUS
displays the current status of the authentication feature and the specifics
of the currently selected authentication protocol. Specifying TACACS or
RADIUS in the command displays the specifics for that authentication
protocol.
Example
The following command displays authentication protocol information
on your switch:
show authentication
The following command displays the information for the RADIUS
protocol:
show authentication=radius