Allied Telesis AT-S63 - Manual (Page 317)

AT-S63 Management Software Command Line Interface User’s Guide
317
SET SWITCH VLANMODE
Syntax
set switch vlanmode=userconfig|dotqmultiple| multiple
[uplinkport=
port ]
Parameters
vlanmode Controls the switch’s VLAN mode. Options are:
userconfig This mode allows you to create your
own port-based and tagged VLANs.
This is the default setting.
dotqmultiple This option configures the switch
for the 802.1Q-compliant multiple
VLAN mode.
multiple This option configures the switch
for the non-802.1Q compliant
multiple VLAN mode.
uplinkport Specifies the port on the switch to function as the
uplink port when the switch is operating in one of the
two multiple VLAN modes. You can specify only one
port.
Description
You use this command to configure the switch for one of the multiple
VLAN modes or so that you can create port-based and tagged VLANs.
If you select one of the multiple VLAN modes, you must also set an
uplink port with the UPLINKPORT parameter. You can specify only one
uplink port.
Note
For background information on the multiple VLAN modes, refer to
Chapter 20, “Multiple VLANs” in the AT-S63 Management Software
Menus Interface User’s Guide.
Examples
The following command configures the switch for the 802.1Q-compliant
multiple VLAN mode and specifies port 4 as the uplink port:
set switch vlanmode=dotqmultiple uplinkport=4