Allied Telesis AT-S63 - Manual (Page 42)

Chapter 3: Basic Switch Commands
42
PURGE IP
Syntax
purge ip [ipaddress] [netmask] [route]
Parameters
ipaddress Returns the switch’s IP address to the default setting
0.0.0.0.
netmask Returns the subnet mask to the default setting
0.0.0.0.
route Returns the gateway address to the default setting
0.0.0.0.
Description
This command returns the switch’s IP address, subnet mask, and default
gateway address to the default settings.
To set these parameters, refer to “SET IP INTERFACE” on page 49 and
“SET IP ROUTE” on page 51. To view the current settings, refer to “SET
SYSTEM” on page 55.
Examples
The following command returns the IP address and subnet mask to the
default values:
purge ip ipaddress netmask
The following command resets just the gateway address to its default
value:
purge ip ipaddress route
The following command resets all three parameters:
purge ip ipaddress