Allied Telesis AT-S63 - Manual (Page 120)

Chapter 7: Port Parameter Commands
120
SHOW INTERFACE
Syntax
show interface= port
Parameter
port Specifies the port whose interface information you
want to display. You can specify more than one port at
a time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22).
Description
This command displays the contents of the interface MIB for a specific
port and provides the following information:
❑ ifIndex - The index of the interface in the interface table.
❑ ifMTU - The size, in octets, of the largest packet that can be
transmitted on this port.
❑ ifSpeed - An estimate of the port’s current bandwidth, in pits per
second.
❑ ifAdminStatus - The configured state of the port, one of the
following:
up - The port is up.
down - The port is down.
❑ ifOperStatus - The current operational status of the port, one of
the following:
up - A valid link exists between the port and the end node.
down - The port and the end node have not established a link.
unknown - The port status is unknown.
❑ ifLinkUpDownTrapEnable - Whether or not link traps have been
enabled for the port, one of the following:
enabled - Link traps are enabled. To disable link traps, see
“DISABLE INTERFACE LINKTRAP” on page 105.