Allied Telesis AT-S63 - Manual (Page 116)

Chapter 7: Port Parameter Commands
116
The following command configures port 8 to operate at 10 Mbps, half
duplex:
set switch port=8 speed=10mhalf
The following command sets the speed to 100 Mbps, the duplex mode
to full duplex, the wiring configuration to MDI-X, and flow control to
enabled for ports 2 to 6:
set switch port=2-6 speed=100mfull mdimode=mdix
flowcontrol=enabled
The following command sets port priority to 5 and activates the
broadcast filter for ports 5, 8, and 12:
set switch port=5,8,12 priority=5 bcastfiltering=enabled
The following command resets port 5:
set switch port=5 softreset