Show stp – Allied Telesis AT-S63 User Manual
Page 205
AT-S63 Management Software Command Line Interface User’s Guide
205
SHOW STP
Syntax
show stp [port=
port
]
Parameter
port
Specifies the port whose STP parameters you want
to view. You can view more than one port at a
time.You can specify the ports individually (for
example, 5, 7, 22), as a range (for example, 18-23), or
both (for example, 1, 5, 14-22).
Description
This command displays the current values for the following STP
parameters:
❑ STP status
❑ Bridge identifier
❑ Bridge priority
❑ Hello time
❑ Forwarding delay
❑ Maximum age timer
You can also use this command to view the following STP parameter
settings for a switch port:
❑ Port cost
❑ Port priority
❑ Port STP state
Examples
The following command displays the switch’s STP settings:
show stp
The following command displays the STP settings for ports 1 to 4:
show stp port=1-4