Enable authentication – Allied Telesis AT-S63 User Manual
Page 420
Advertising
Chapter 32: TACACS+ and RADIUS Commands
420
ENABLE AUTHENTICATION
Syntax
enable authentication
Parameters
None.
Description
This command enables TACACS+ or RADIUS manager account
authentication on your switch. To select an authenticator protocol, refer
to “SET AUTHENTICATION” on page 422.
Note
If you are using the RADIUS authentication protocol for 802.1x Port-
based Network Access Control but not for manager account
authentication, you do not need to use this command. You can leave
the RADIUS manager account feature disabled. The switch still has
access to the RADIUS configuration information for 802.1x port-
basec access control.
Example
The following command enables authentication on your switch:
enable authentication
Advertising