Allied Telesis AT-S63 - Manual (Page 230)

Chapter 19: MSTP Commands
230
PURGE MSTP
Syntax
purge mstp
Parameters
None.
This command returns all MSTP bridge and port parameters settings to
their default values.
In order for you to use this command, MSTP must be the active spanning
tree protocol on the switch and the protocol must be disabled. To select
MSTP as the active spanning tree protocol on the switch, see “ACTIVATE
MSTP” on page 223. To disable MSTP, refer to “DISABLE MSTP” on page
228.
Example
The following command resets the MSTP bridge and port parameter
settings:
purge mstp