Allied Telesis AT-S63 - Manual (Page 337)

AT-S63 Management Software Command Line Interface User’s Guide
337
Note the following before using this command:
❑ You must first create the protected ports VLAN by giving it a name
and a VID before you can add ports. Creating a VLAN is
accomplished with “CREATE VLAN PORTPROTECTED” on page
339.
❑ Both command syntaxes perform the same function. The
difference is that with syntax 1 you can add ports of only one type,
tagged or untagged, at a time. With syntax 2, you can add both at
the same time.
❑ If you are adding an untagged port to a group, the port cannot be
an untagged member of another protected port VLAN. It must be
an untagged member of the Default_VLAN or a port-based or
tagged VLAN. To remove a port from a protected port VLAN, use
“DELETE VLAN” on page 340.
❑ You cannot add a new uplink port to a VLAN if the VLAN has
already been assigned an uplink port. Instead, you must delete
the existing uplink port(s) using the “DELETE VLAN” on page 340
and then re-add the uplink port(s) using this command.
❑ You cannot add ports to an existing group. To modify an existing
group, you must delete the group by removing all ports from it,
using “DELETE VLAN” on page 340, and then add the ports back to
the group using this command.
Examples
The following command uses Syntax 1 to specify that port 11 is to be an
untagged uplink port for the protected ports VLAN called
InternetGroups:
add vlan=InternetGroups ports=11 frame=untagged group=uplink
The following command accomplishes the same thing using Syntax 2:
add vlan=InternetGroups untaggedports=11 group=uplink
The following command uses Syntax 1 to create group 4 in the
InternetGroups VLAN. The group will consist of two untagged ports, 5
and 6:
add vlan=InternetGroups port=5,6 frame=untagged group=4