Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 116)

116 Publication 1404-UM001F-EN-P - November 2009
Chapter 4 Communication
2. Fill out the Setup dialog as shown.
Notice that under target device that power monitor data table
N11 (Date and Time) was selected. The Local Node Address is
the address of the power monitor Controlnet Node Address 4.
Writing Files to the Power Monitor
Writing data to the power monitor is done with the same method. It is
recommended that 1 integer file and 1 float file be set aside in the SLC
controller for use when writing to the power monitor. Data to be
written to the power monitor is loaded in one of these files according
to data type before the transaction is started. The following example
writes data to the power monitor.
1. Select PLC5 for your Target Device, Local Network, and Control
Block.