Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 41)

Publication 1404-UM001F-EN-P - November 2009 41
Powermonitor 3000 Unit Operations Chapter 3
Display
Configuration
Display
Status
Program
Commands
L1
L2
L3
N
Program
Configuration
L1
L2
L3
N
See Config.
Menu
Catalog Number
Accuracy Class
WIN Number
Hardware Revision
Master Module FRN
Device ID
Selftest Status
Code Flash
RAM
Data Flash
NVRAM
Data Acquisition
Watchdog Timer
Clock
Optional Comms
(Version Number,
Identifier Type, Status)
DM Status
DM FRN
Date
Time
Relay Status
KYZ Status
S1 Status
S1 Count
S2 Status
S2 Count
Output Word
Force Relay
Force KYZ
Clear Min/Max Log
Clear kWH Counter
Clear kVARH Counter
Clear kVAH Counter
Clear Amp H Counter
Clear All Energy Counters
Clear S1 Counter
Clear S2 Counter
Restore Defaults
Clear Setpoint Timers
L1
L2
L3
N
See Config.
Menu
Level 3
Basic
Wiring Mode
PT Primary
PT Secondary
CT Primary
CT Secondary
I4 Primary
I4 Secondary
Nominal Sys Voltage (7)
Native
Comm.
Protocol
Delay
Baud
Address
Format
Optional
Comm.
Depends on
communications
options
(see Chapter 4)
Min/Max
Log
Enable/Disable -
Min/Max Log
Event
Log
Log Status
Input Changes
Setpoint (6)
1..n
Type
Evaluation
High Limit
Low Limit
Pickup Del.
Dropout Del.
Output Action
Accumu. Time (5)
Status
DST
Enable
Start Month
Start Day
Start Day Inst.
Start Hour
End Month
End Day
End Day Inst.
End Hour
Network/
Demand Time
Input Mode
Broadcast Port
Time IP Addr.
World Time Zone
Time Set Interval
SNTP Addr 2
SNTP Addr 3
Advanced
New Password
Demand Period Length
# Of Demand Periods
Forced Demand Delay
Projected Demand Type
KYZ Control Source
KYZ Pulse Scale
KYZ Pulse Width
Relay Control Source
Relay Pulse Scale
Relay Pulse Width
RMS Resolution
RMS Averaging
Frequency Averaging
Date Format
Date
Time
Relay State on Comms Loss (8)
KYZ State on Comms Loss (8)
Watch Dog Action
DM Scroll Rate
Energy Digits
Configuration Menu
(5) In Program Mode, this entry becomes Clear Accumulated Time.
(6) 1..10 (M4, M5) or 1..20 (M6, M8).
(7) Available on M6 and M8 only.
(8) Applies to EtherNet/IP, ControlNet, DeviceNet and remote I/O neworks only.
Level 2