Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER User Manual
Page 122
122
Publication 1404-UM001F-EN-P - November 2009
Chapter 4 Communication
User-configured I/O Table
You may configure Input Messaging Instance 1 in Powermonitor 3000
units with optional DeviceNet, EtherNet/IP, or ControlNet
communication in the same way as the user-configured data table
above. You have one additional option for Instance 1: you may select
the data type of Instance 1 as integer (0) or floating-point (1).
If you change the configuration of Instance 1, an existing Class 1
connection will fault. You need to edit the properties of the
connection with the parent controller to reflect the new size of
Instance 1.
TIP
Refer to the Rockwell Automation KnowledgeBase
(
.ab.com
) for additional information on setting up a
user-configured I/O instance.