Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 68)

68 Publication 1404-UM001F-EN-P - November 2009
Chapter 4 Communication
To use the auto configure you must first select the device as
SLC-CH0/Micro/PanelView.
4. Click Auto Configure to start the process.
The configuration returns with the following message. This
message can be disregarded. Recognition of the device is
provided after exiting the auto configuration routine.
5. Click OK and disregard this message.