Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 45)

Publication 1404-UM001F-EN-P - November 2009 45
Powermonitor 3000 Unit Operations Chapter 3
1. Using the four display module keys, move into Program mode
and display the command to be issued.
Notice the flashing phase indicators on the right-hand side.
Program Mode
2. Set the display module into Edit mode by pressing the Enter key.
Notice that the phase indicators on the right-hand side are now
solid and the command option prompt is now flashing.
Edit Mode
ATTENTION
The relay and KYZ outputs may be connected to field devices. Before
issuing a command to force an output, ensure that any devices
connected to outputs cannot operate in an unsafe or undesired
manner. Failure to follow these instructions may result in personal
injury or death, property damage, or economic loss.
FORCE
UP-DN
L1
L2
L3
N
Powermonitor 3000
RELAY
UP-DN
L1
L2
L3
N
Powermonitor 3000