Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 231)

Publication 1404-UM001F-EN-P - November 2009 231
Powermonitor 3000 Data Tables Appendix A
List of Event Types Parameters
Applies to Event Log Results Parameters on page 229
PM3000 Type See table
List of Event Types
Event
Code. M4
M5 M
6 M
8 Event Type Event Command
Code Comment
0
• • •
No event 0 The log starts with no events recorded
1
• • •
Setpoint triggered Setpoint Number A setpoint activated
2
• • •
Setpoint released A previously active setpoint released
3
• • •
Relay force energized Relay Number 1 = Form C relay, 2 = KYZ
4
• • •
Relay force de-energized
5
• • •
Relay force released
6
• • •
Status input set Status Input Number
7
• • •
Status input cleared
8
• • •
kWh counter set or cleared 1 Records command action
8
• • •
kVARh counter set or cleared 2
8
• • •
kVAh counter set or cleared 3
8
• • •
Ah counter set or cleared 4
8
• • •
All energy counters cleared 5
8
• • •
Trend log cleared 6
8
• • •
Min/max log cleared 7
8
• • •
Factory defaults restored 8
8
• • •
Status input #1 counter cleared 9
8
• • •
Status input #2 counter cleared 10
8
• • •
Reserved 11
8
• • •
Single setpoint timer cleared 12
8
• • •
All setpoint timers cleared 13
9
• • •
Power-up 0 Control power was applied
10
• • •
Power-down 0 Control power was lost or internal reset occurred
11
• • •
Selftest failure Status Error Code Refer to Status Error Codes (bitfield)
12
• • •
Date/time set 0 The date and/or time was set or altered
13
• • •
Change of non-setpoint config data 0
14
• • •
Change of setpoint config data 0
15
• • •
NVRAM Clr 0 NVRAM has been cleared due to an extended loss
of control power or internal error
16
•
Transient detected