Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 335)

Publication 1404-UM001F-EN-P - November 2009 335
Appendix
D
Technical Specifications
Product Approvals Powermonitor 3000 units have the following approvals and
certifications.
EtherNet/IP Conformance Testing
All products equipped with an EtherNet/IP communication port bear
the mark shown below. This mark indicates the power monitor unit
has been tested at an Open Device Vendor Association (ODVA)
independent test lab and has passed the EtherNet/IP conformance
test. This test provides a level of assurance that the power monitor
will interoperate with other conformance tested EtherNet/IP devices
(including devices from other vendors). Two representative devices
from the power monitor EtherNet/IP family of devices; the
1404-M405A-ENT B and the 1404-M8805A-ENT B have been tested by
ODVA using EtherNet/IP Conformance Test version A2.8. The ODVA
website (
http://www.odva.org ) maintains a list of products that have
passed the conformance test at one of their test labs.
ControlNet Conformance Testing
All products equipped with a ControlNet communication port bear the
mark shown below. This mark indicates the power monitor has been
tested at a ControlNet International (CI) independent test lab and has
passed the ControlNet conformance test. This test provides a level of
assurance that the power monitor will interoperate with other
conformance tested ControlNet devices (including devices from other
vendors). Two representative device from the power monitor
ControlNet family of devices; the 1404-M405A-CNT A and the
1404-M805A-CNT A have been tested by CI using ControlNet
Conformance Test version 12. The CI website
(
http://www.ControlNet.org ) maintains a list of products that have
passed the conformance test at one of their test labs.