Rockwell Automation 1746-HSRV SLC Servo Control Module User Manual - Manual (Page 13)

Publication 1746-6.1.2 - July 2000
Preface P-2
Contents of this Manual This manual provides specific information relevant to the SLC Servo
Module. The following table identifies the chapters, titles, and
contents.
ATTENTION
!
Only those familiar with the SLC Servo Control
Module and associated machinery should plan or
implement the installation, start-up, and subsequent
maintenance of the system. Failure to comply can
result in personal injury and/or equipment damage.
This product contains stored energy devices. To
avoid hazard of electrical shock, verify that all
voltage on the capacitors has been discharged before
attempting to service, repair, or remove this unit. You
should only attempt the procedures in this manual if
you are qualified to do so and familiar with
solid-state control equipment and the safety
procedures in publication NFPA 70E.
The system integrator is responsible for local safety
and electrical codes.
ATTENTION
!
An incorrectly applied or installed controller can
result in component damage or a reduction in
product life. Wiring or application errors, such as
undersizing the motor, incorrect or inadequate AC
supply, or excessive ambient temperatures can result
in malfunction of the drive.
This product contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control
precautions are required when installing, testing,
servicing, or repairing this assembly. Component
damage can result if ESD control procedures are not
followed. If you are not familiar with static control
procedures, refer to Allen-Bradley publication
8000-4.5.2, Guarding Against Electrostatic Damage
or any other applicable ESD Protection Handbook.