Rockwell Automation 1746-HSRV SLC Servo Control Module User Manual - Manual (Page 40)

Publication 1746-6.1.2 - July 2000
Installing Your SLC Servo Module 4-5
Mounting the Termination
Panel Refer to the Figure 4.3 and Figure 4.4 when mounting the 1746HT
termination panel.
To mount the 1746HT termination panel:
1. Snap the termination panel onto the DIN-type rail (1492-DR2).
2. Position an end anchor on either end of the termination panel.
3. Secure the panel by tightening the end anchor screws.
The end anchor prevents the termination panel from sliding in either
direction on the DIN rail.
Figure 4.3 Mounting the Termination Panel
D R IV E
D R IV E
D R R E T
S H L D
E N C O D E R
C H A . H I
C H A . L O
A B S H L D
C H B . H I
C H B . L O
Z S H L D
C H Z . H I
C H Z . L O
E N C O D E R P O W E R
DIN Rail
End Anchor & Screw
Termination Panel