Rockwell Automation 1746-HSRV SLC Servo Control Module User Manual User Manual
Page 85
Publication 1746-6.1.2 - July 2000
7-6 Setting Up Your SLC Servo Module
10. Select OTHER. In the Module ID Code area, type 10114. The ID
of the SLC Servo Module automatically creates twelve input
words and twelve output words.
11. Press Enter.
To set the file length and enter parameters:
1. Press F9 (SPIO CONFIG).
2. Press F5 (ADVNCD SETUP).
3. Press F5 and set the M0 file length to 1664 words.
4. Press Enter.
5. Press F6 and set the M1 file length to 1659 words.
6. Press Enter.
7. Press ESC.
8. Press F7 and set the G file size to 0 words.
9. Press Enter.
10. Press ESC.
11. Press F8 (EXIT).
12. Press F8 (SAVE AND EXIT).
13. Press F8 (MONITOR FILE).
14. Press F8 (DATA MONITOR) from the top screen of the Offline
Editor screen to enter parameters into Bit (B), Integer (N), or
Float (F) files.
IMPORTANT
Use F1 to change the radix between binary and
decimal.