MITSUBISHI ELECTRIC QJ71C24N - Manual (Page 64)

3 - 14 3 - 14
MELSEC-Q
3 SPECIFICATIONS
3.7 List of GX Developer Setting Items for Serial Communication Modules
The following table lists the parameters that are set using the GX Developer.
Parameter setting item Parameter description Set data Reference section
Type
Model name
Points
I/O assignment setting
Performs I/O assignment
for the Q series C24 and
enables the switch settings
listed below. Start X/Y
Section 4.5.1
CH1 Transmission setting
Switch 1
CH1 Communication rate setting
Switch 2 CH1 Communication protocol setting
CH2 Transmission setting
Switch 3
CH2 Communication rate setting
Switch 4 CH2 Communication protocol setting
Switch setting
Switch 5 Station number setting
Section 4.5.2
Interrupt pointer Start No.
CPU side
Interrupt pointer No. of units
Start I/O No.
Interrupt pointer setting
Performs setting for
reading reception date with
interrupt programs.
Intelligent
module side Start SI No.
Section 4.5.3
Password settings
Model name
Remote password settings
Sets the remote password
and the Q series C24 that
performs the check.
Password
active module
settings
Start XY
Section 3.3.3 of
User's Manual
(Application)