Panasonic MN103001G/F01K - Manual (Page 380)

I/O Ports
15-14
15.3.3 Pin Configurations
Table 15-3-1 shows the pin configurations for port 1.
Table 15-3-1 Port 1 Configuration
Port Pin P1n P1M = "1" P1M = "0"
No. P1nD = "1" P1nD = "0"
Port 1 96 P10 General-purpose output port General-purpose input port D0 * 1 Data input/output
<<AS>> <<Address strobe output *Setting invalid>>
95 P11 General-purpose output port General-purpose input port D1 * 1 Data input/output
<<RWSEL>> <<Read/write select output *Setting invalid>>
94 P12 General-purpose output port General-purpose input port D2 * 1 Data input/output
93 P13 General-purpose output port General-purpose input port D3 * 1 Data input/output
91 P14 General-purpose output port General-purpose input port D4 * 1 Data input/output
90 P15 General-purpose output port General-purpose input port D5 * 1 Data input/output
89 P16 General-purpose output port General-purpose input port D6 * 1 Data input/output
88 P17 General-purpose output port General-purpose input port D7 * 1 Data input/output
[Note 1]
: When reset (in address/data separate mode)
"General-purpose input port" is selected in address/data multiplex mode . pin No. 95 and 96,
however, are set as RWSEL and AS, respectively.
*1 : In the event of a reset in address/data separate mode , the P1PU bit in the P1MD register is set
to "1" and the data pins (the 8 bits D[7:0]) are pulled up.
<<>> : These pins are set in address/data multiplex mode .
Setting invalid: In address/data multiplex mode , pin No. 95 is used only for RWSEL, and pin No. 96 is used
only for AS; the P1MD and P1DIR settings are invalid.
[Note 2]
Setting P1M to "0" in address/data multiplex mode is prohibited.
[Note 3]
When the bus authority is granted, D7 to D0, AS, and RWSEL go to high impedance.