Panasonic MN103001G/F01K - Manual (Page 406)

I/O Ports
15-40
Port 6 output mode register
Register symbol: P6MD
Address:
x'3600802C
Purpose: This register selects the content output on the port 6 pins.
Bit No. 7 6 5 4 3 2 1 0
Bit name - - - - P63M P62M P61M P60M
Reset 0 0 0 0 1 1 1 1
Access R R R R R/W R/W R/W R/W
When P6nM is "0", the timer input/output signal is selected. The input/output setting for the timer input/output
signal is also changed by P6nD.
15.8.3 Pin Configurations
Table 15-8-1 shows the pin configurations for port 6.
Table 15-8-1 Port 6 Configuration
Port Pin P6n P6nM = "1" P6nM = "0"
P6nD = "1" P6nD = "0" P6nD = "1" P6nD = "0"
Port 6 59 P60 General-purpose output port General-purpose input port TM6IO Timer 6 output Timer 6 input
58 P61 General-purpose output port General-purpose input port TM7IO Timer 7 output Timer 7 input
57 P62 General-purpose output port General-purpose input port TM10IOA Timer 10 output A Timer 10 input A
56 P63 General-purpose output port General-purpose input port TM10IOB Timer 10 output B Timer 10 input B
[Note 1]
: When reset (whether in address/data separate mode or address/data multiplex mode)
[Note 2]
When Pin No. 56 to 59, respectively, are set as
external interrupt input pins (IRQ3 to 0), or if pin No. 56 is set as
the A/D conversion trigger input pin (ADTRG), the pins must be set as a general-purpose input port as shown in
the above table.