Rainbow Electronics MG260 - Manual (Page 10)

FLYFOT-MG260-MODULE
Page: 10 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
1 Introduction
1. Scope of this document
This document describes the AT-command based messages exchanged between an application and the
FLYFOT products in order to manage GSM related events or services.
1.1 Related documents
This interface specification is based on the following recommendations:
[1] ETSI GSM 07.05: Digital cellular telecommunications system (Phase 2); Use of DTE-DCE
interface for Short Message Service (SMS) and Cell Broadcast Service (CBS)
[2] ETSI GSM 07.07: Digital cellular telecommunications system (Phase 2); AT command set
for GSM Mobile Equipment (ME)
[3] ITU-T Recommendation V.25 ter: Serial asynchronous automatic dialling and control
[4] ETSI GSM 03.40: Digital cellular telecommunications system (Phase 2); Technical
implementation of the Short Message Service (SMS) Point-to-Point (PP)
[5] ETSI GSM 03.38: Digital cellular telecommunications system (Phase 2); Alphabets and
language-specific information
[6] ETSI GSM 04.80: Digital cellular telecommunications system (Phase 2): Mobile radio
interface layer 3, Supplementary service specification, Formats and coding
1.2 ETSI secretariat
The following addresses may be of use in obtaining the latest GSM
recommendations:
Postal address: F-06921 Sophia Antipolis CEDEX – France
Office address: 650 Route des Lucioles – Sophia Antipolis – Valbonne – France
1.3 Definitions
The words, “Mobile Station” (MS) or “Mobile Equipment” (ME) are used for mobile terminals
supporting GSM services.
FLYFOT MG260 Module