Rainbow Electronics MG260 - Manual (Page 206)

FLYFOT-MG260-MODULE
Page: 206 / 246
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Defined values
<Mode>
0 : Stop the battery charging (default).
1 : Start the battery charging.
2 : Get the current battery voltage.
3 : Set the battery charge parameters.
Note :
When <Mode> = 0 or 1, only the <ChargeInd> parameter can be set.
When <Mode> = 2, no additional parameter can be set.
When <Mode> = 3, all others parameters can be set.
<ChargeInd>
0 : Disable the battery charge unsolicited indications (default value).
1 : Enable the battery charge unsolicited indications (see +WBCI description).
<BattLevelMax> : Maximum level for the battery voltage. When reached, the battery is considered as
charged. The allowed range is [4000 ; 5000] (in mV, default value is 4200)
<BattLevelMin> : Minimum level for the battery voltage. When reached, the battery is considered as
discharged, and the product is turned off (with the +CPOF command behavior). The allowed range is
[2800 ; 3800] (in mV, default value is 3100)
Note :
The <BattLevelMax> and <BattLevelMin> parameters cannot be changed during the battery charging
(when <Mode> = 1).
<TPulseInCharge> Time between pulses for the pulsed charge.
The pulse duration lasts one second. When the battery charging is started with unsolicited charging
indications (<ChargeInd>= 1), +WCBI responses are returned by the ME with a period equals to
(<Pulse Time> (= 1s.) +<TPulseInCharge>).
The allowed range is [100 ; 10000]. (unit is ms, default value is 100).
<TPulseOutCharge> Time between +WBCI unsolicited responses, when the battery charge is
stopped with charging indications requested (<ChargeInd> = 1).
The allowed range is [100 ; 10000] (in ms, default value is 5000).
<BattIntRes> : Battery Internal Resistor.
This parameter must be set to have correct values with +WBCI unsolicited results.
The allowed range is [0 ; 255] (in mΩ, default value is 0)